Honda GX240RT2 Service And Repair Manual page 282

OIL LEVEL SWITCH REMOVAL/
INSTALLATION
(*) Refer to page of base shop manual (GX240/GX270/
GX340/GX390UT2, P/N 61Z5F00E3).
Drain the engine oil
Disconnect the oil level switch connector (1).
Remove the two 6 x 16 mm flange bolts (2), oil level
switch (3), and O-ring (4).
Installation is in the reverse order of removal.
Replace the O-ring
with a new one.
• Install the oil level switch to the crankcase securely
as shown.
• Wrong assembly can cause the engine trouble.
OIL LEVEL SWITCH INSPECTION
Remove the oil level switch
Check for continuity between the oil level switch termi-
nals as follows:
1. Hold the oil level switch (1) in the direction as
shown. There should be continuity.
2. Hold the switch in the direction as shown. There
should be no continuity.
3. Hold the switch in the direction as shown and dip the
float section of the switch into a container of oil.
There should be no continuity.
If the correct continuity is not obtained, replace the oil
level switch
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 3-4)*.
(page 11-5).
(page 11-5).
OTHER ELECTRICAL
(1)
(4)
(3)
(2)
GX390: GX270:
CUTOUT
DIRECTION OF THE SWITCH INSPECTED IN
STEP 1 AND 3:
DIRECTION OF THE SWITCH INSPECTED IN
STEP 2:
CUTOUT
(1)