Maximum Speed Adjustment; Governor Arm Installation; (Without Auto Throttle Type) - Honda GX690 Workshop Manual

MAXIMUM SPEED ADJUSTMENT

Start the engine and allow it to warm up to normal
operating temperature.
Turn the pan screw (1) of the control to obtain the
specified maximum speed.
MAXIMUM SPEED: 3,850 ± 150 min

GOVERNOR ARM INSTALLATION

(Without auto throttle type)

Install the governor arm (1) on the governor arm shaft
(2) by aligning the cutout.
Tighten the governor arm nut (3).
TORQUE: 11 N·m (1.1 kgf·m, 8 lbf·ft)
Connect the governor rod (4) and throttle return spring
(5) to the governor arm and carburetor.
Loosen the governor sub arm nut (6).
Rotate the governor arm counterclockwise to fully open
the carburetor throttle valve.
Rotate the governor sub arm (7) counterclockwise as
far as it will go.
Hold the governor arm and governor sub arm, tighten
the governor sub arm nut securely.
-1 (rpm)
-1
3,150 ± 150 min (rpm)
(GX630R QYD, VEP4, GX660R
VXF types only)
3,200 ± 150 min -1 (rpm)
(GX630R VXD8, VXE1, GX660R
VXE1, GX690R VXE types only)
GOVERNOR SYSTEM
(4)
(2)
(5)
(3)
(1)
(7)
(6)
(1)
7-3