Control Base Assy. Disassembly/ Assembly; Manual Operation Type - Honda GX240RT2 Service And Repair Manual

GOVERNOR SYSTEM
CONTROL BASE ASSY.
DISASSEMBLY/ASSEMBLY

MANUAL OPERATION TYPE

Remove the control base assy
LEVER SPRING
CONTROL LEVER
CONTROL LEVER
SPACER
CONTROL BASE
CONTROL ADJUST
SPRING
SCREW (5 x 32 mm)
(If equipped)
ASSEMBLY:
Adjust the maximum
(page 7-8)
speed .
SCREW (5 x 25 mm)
(If equipped)
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 7-2).
SELF-LOCK NUT (6 mm)
ASSEMBLY:
After tightening the nut fully,
loosen it 1-1/2 turns.
CONTROL LEVER
WASHER
ASSEMBLY:
Install the control lever
washer by aligning the
cutout of the control
lever washer with the
claw of the control
base.
ASSEMBLY:
Note the installation
direction.
STOPPER COLLAR
(If equipped)
WIRE HOLDER
(If equipped)
CIRCLIP (5 mm)
(If equipped)
CLAW
SCREW (4 x 6 mm)
(If equipped)
CABLE RETURN SPRING
INSTALLATION:
Install with the short end
of the spring toward the
control base.
Hook the cable return
spring to the hole of the
control lever.