BRUSH REPLACEMENT
Cut off the brush lead (1) at the point shown and
remove the brush (2).
Remove the remaining brush lead and deposited solder
from the terminal (3).
Hold a new brush (1) in the same direction of the
removed brush and put a new plate (2) over the new
brush and terminal (3), and press it using a pair of pliers
as shown.
Solder the plate (1) on the terminal (2).
• Before soldering, heat the pressed part of the plate
well to mark sure solder (3) reaches the end of the
pressed part.
• Prevent solder from flowing down the brush lead.
• Do not allow solder to run down onto the field wind-
ing of the yoke.
• File the brush so that the brush and commutator can
fit using an emery paper #500 or #600.
gx240ut2_gx270ut2_gx340ut2_gx390ut2
STARTING SYSTEM
(3)
Cut here
(1)
(3)
(2)
Solder here
(1)
(3)
(2)
(2)
Press here
Press here
(1)