Honda GX240RT2 Service And Repair Manual page 185

CRANKCASE
P.T.O. SHAFT BEARING (6206)
Drive out the radial ball bearing (1).
Apply oil to the circumference of a new bearing (2).
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
TOOLS:
Attachment, 62 x 64 mm (3)
Pilot, 30 mm (4)
Driver (5)
P.T.O. SHAFT OIL SEAL
(30 x 46 x 8 mm)
Remove the oil seal from the crankcase cover.
Apply grease to the lip of a new oil seal (1).
Drive the oil seal in the position as shown using the
special tools.
TOOLS:
Attachment, 45 x 50 mm (2)
Driver (3)
P.T.O type
gx240ut2_gx270ut2_gx340ut2_gx390ut2
07947-6340400
07746-0040700
07749-0010000
07946-6920100
07749-0010000
(page 1-3).
(5)
(3)
CIRCUMFERENCE
(3)
(2)
* L TYPE:
2 mm (0.08 in)
* H TYPE:
3 mm (0.11 in)
OIL SEAL LIP
(1)
(2)
(4)
(1)