Charge Coil Inspection - Honda GX240RT2 Service And Repair Manual

CHARGING SYSTEM

CHARGE COIL INSPECTION

10A/18A CHARGE COIL/LAMP COIL TYPE
Disconnect the charge/lamp coil connectors.
Measure the resistance between the terminals of the
charge/lamp coil.
Resistance:
Charge coil 10 A:
Charge coil 18 A:
Lamp coil 12 V-25 W:
Check for continuity between each terminal and engine
ground.
There should be no continuity.
• If the measured resistance is not within the range
specification or if any wire has continuity to engine
ground, replace the charge coil
• If the resistance is good and the flywheel is ok,
replace the charge coil and retest.
1A/3ACHARGE COIL TYPE
Disconnect the charge coil connector.
Check for continuity between terminal and engine
ground.
Resistance:
Charge coil 1 A:
Charge coil 3 A:
There should be no continuity.
If the resistance is good and the flywheel is ok, replace
the charge coil and retest.
gx240ut2_gx270ut2_gx340ut2_gx390ut2
0.16 - 0.24
0.10 - 0.30
0.30 - 0.46
(page 8-9).
3.00 - 4.00
0.62 - 0.93
10 A / 18 A CHARGE COIL / LAMP COIL TYPE:
18A CHARGE
COIL / LAMP
COIL TYPE:
Inspect between
each terminals.
1A / 3A CHARGE COIL TYPE:
10 A CHARGE
COILTYPE: