Honda GX240RT2 Service And Repair Manual page 272

STARTER MOTOR DISASSEMBLY/
ASSEMBLY
Remove the starter motor
LOCK RING
DISASSEMBLY:
Hold the armature upright,
place an offset wrench
over the pinion stop collar,
and drive the collar down
exposing the lock ring.
Remove the lock ring; then
remove the collar and
overrunning clutch.
PINION DRIVE LEVER
NUT (6 mm) (2)
FRONT BRACKET
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 10-8).
LOCK RING
PINION
STOP
COLLAR
PINION GEAR
PINION STOP
COLLAR
THRUST
COLLAR
BEARING A
BRUSH HOLDER
ARMATURE
STARTER
SOLENOID
OVERRUNNING
CLUTCH
BRUSH SPRING (4)
BRUSH (4)
STARTING SYSTEM
YOKE
ASSEMBLY:
Make sure there is no
obstruction on the magnets.
BRUSH TERMINAL
NUT (8 mm)
THROUGH BOLT
(5 x 99 mm) (2)
BEARING B
REAR BRACKET
COVER
BRUSH HOLDER
INSULATOR
INSPECTION:
Check for cracks or damage.