CHARGE COIL INSPECTION
Disconnect the charge coil connector/s.
Measure the resistance between the terminals of the
charge coil.
Resistance:
2.7 A: 1.95 - 2.93
17 A: 0.18 - 0.28
26 A: 0.17 - 0.25
Check for continuity between each terminal and engine
ground.
There should be no continuity.
If the measured resistance is not within the range
specification or if any wire has continuity to engine
ground, replace the charge coil (page 8-6).
REGULATOR/RECTIFIER SYSTEM
INSPECTION
Disconnect the regulator/rectifier connector (1) and
check the regulator/rectifier connector terminals (wire
harness side) as follows:
Item
Battery charging
line
Charge coil line
Ground line
Terminal
Specification
White
(+)
Battery voltage should
and ground
register
Gray
and
2.7A: 1.95 - 2.93
ground
17A: 0.18 - 0.28
26A: 0.17 - 0.25
Black and
Continuity should exist
ground
CHARGING SYSTEM
2.7 A / 17 A TYPES:
26 A TYPE:
Inspect between
each terminals.
(1)
8-7