Routing And Effect Settings; Effect Settings For A Program - Korg KROSS Operation Manual

Using Effects
input settings of the KROSS in G-SET (Use Global
Settings), or use the individual parameters of each mode to
specify the BUS or Send settings. (see "Effect settings for
audio input" on page 71)
Depending on the type of effects that you're using on
the external audio input, and on their settings, it is
possible for feedback to occur. If this occurs, adjust the
input/output levels and the effect settings. Take special
care when using high-gain effects.
Audio recorder
The audio recorder can record the sound as it is processed by
the effects specified in Program, Combination, or Sequencer
mode.
You can't apply effects to the playback of the audio
recorder.
Pad Sampler, USB Audio
Effects cannot be applied to the playback of the pad
sampler, nor to the USB audio input.
REC
Audio Recorder
PLAY
Oscillator1 Filter1 Amplifier1
Oscillator2 Filter2 Amplifier2
Line In (stereo)
Mic In (mono)
Input
USB Audio
Output
68
Send Master Return
Effect 1, 2
Insert
OUTPUT
Effect 1–5
L/MONO, R

Routing and effect settings

Routing lets you specify how each sound will be connected
to the various effects. In each mode, you can adjust settings
for the program's oscillators, the combination's timbres, and
the song's tracks.
Here we'll explain how to adjust routing settings in each
mode, and how to edit the effect settings.

Effect settings for a program

Routing
1. Access the P-FX ROUTING> BUS page.
2. "Bus (Bus Select)" specifies the bus where the output
from the oscillators will be sent. Here we'll choose
IFX1 so that the output of the oscillators will be sent
to insert effect 1.
L/R: The oscillator output will not be sent to an insert
effect. It will pass through the total effect, and then be
sent to OUTPUT L/MONO and R.
IFX1–IFX5: The oscillator output will be sent to insert
effect 1–5.
Off: The oscillator output will not be sent to OUTPUT L/
MONO or R, or to insert effects 1–5. Choose this if you
want to send the sound directly to the master effects at the
send levels specified by Send1 (to MFX1) or Send2 (to
MFX2) (P-FX ROUTING> SEND page).
3. If you selected L/R or Off in step 2, you can use each
oscillator's Send1 (to MFX1) and Send2 (to MFX2)
parameters to set the send levels to the master effects.
Adjust these settings in the P-FX ROUTING> SEND
page.
If Bus (Bus Select) is set to IFX1–5, the send levels from
the output of each insert effect to the master effects are
specified by the S1 (Send1) and S2 (Send2) parameters
(P-Fx Routing Mixer page). (see step 6 of the next
section, "Insert effects")
4. "FX Control Bus" sends the output of oscillators 1
and 2 to the FX control bus.
Use this when you want to use a different sound to
control the sound that's being input to an effect. You can
use two FX control buses to freely control the sound. (see
"FX Control Bus" on page 209 of the Parameter Guide)