Korg KROSS Operation Manual page 20

Introduction to the KROSS
Selecting and executing functions
The functions provide commands that are specific to each page,
such as Write (save) or Copy. The available functions will depend
on the selected page.
For example, the functions in Program mode let you write (save)
the settings, or let you perform convenient editing procedures
such as copying settings between oscillators or effects, or a Sync
function that lets you edit two EGs together.
1. Press the FUNCTION button.
The function list will appear.
2. Use the PAGE+ (▼) and PAGE– (▲) buttons to select
a function, and press the MENU (OK) button.
A dialog box for the selected function will appear.
Check-type commands will not display a dialog box; their
status will be switched, and the list will close.
• If you want to close the list without selecting a
command, press the FUNCTION (CLOSE) button once
again.
3. Use the ◄►▲▼ cursor buttons to select parameters
in the dialog box, and use the VALUE dial, ENTER
button, and ▲▼ cursor buttons to enter the value.
You can use the CATEGORY dial and VALUE dial when
selecting a program or combination number in the dialog
box.
4. To execute, press the MENU (OK) button.
If you decide not to execute, press the FUNCTION
(CANCEL) button.
The dialog box will close.
14
Writing/saving
After editing, you should write or save your changes as necessary.
For example if you've edited a program, your changes will be lost
if you select another program or turn off the power. The same
applies to a combination.
Settings that you edit in Global/Media mode, songs and Favorites
will be remembered as long as the power is on, but your changes
will be lost when you turn off the power, unless you write these
changes into memory.
For more details on the Write procedure, see the following pages.
• Programs → p.122
• Combinations → p.122
• Favorites → p.54
• Global settings (GLOBAL–G-USER SCALE) → p.124
• Drum kits → p.124
• User arpeggio pattern → p.124
• User template songs → PG p.140
• For details on writing to internal memory → p.122
Please see the following pages for more information about
saving.
• Saving a MIDI song → p.65
• Saving to SD card → p.121
Note: On the KROSS, the action of writing into internal memory is
called "Writing," and the action of saving to an SD card device is
called "Saving."
Assigning a name (renaming)
You can edit the name of an edited program, combination, song,
drum kit, or arpeggio pattern.
For additional details, please see "Editing names" on page 124.