Effect Settings For Audio Input - Korg KROSS Operation Manual

Insert effects
1. Access the C-FX ROUTING> IFX page.
2. Select an insert effect for each IFX1–5, and edit its
settings.
3. Access the C-IFX page. Select the IFX1–5 pages, and
edit the effect parameters in each page.
You can adjust these settings in the same way as a
program. (see page 69)
You can use MIDI to control each effect's dynamic
modulation (Dmod) and the "Pan (CC#8)," "Send1,"
and "Send2" following the insert effect. These settings
are controlled on the MIDI channel specified by "Ctrl
Ch." For timbres that are routed to an insert effect, a "*"
symbol is shown to the right of the channel number
Ch01–16. If multiple timbres with differing MIDI
channel settings are routed, you can specify here the
channel where control will occur.
Master effects
You can adjust these settings in the same way as a program.
(see page 69)
Dynamic modulation (Dmod) for the master effects and
total effect can be controlled on the MIDI channel
specified by "Ctrl Ch."
Routing and effect settings Effect settings for audio input

Effect settings for audio input

You can apply the KROSS's effects to an external audio
input from the LINE IN jack or MIC IN jack, and record it
on the audio recorder or pad sampler; you can also apply an
effect to the mic input or line input along with the program
or combination that you're playing. In addition, you can use
a vocoder effect (D09: Vocoder) that uses the external mic
input to control an internal sound.
Normally, the settings of the Global/Media mode G-INPUT>
AUDIO IN page are shared. For special cases, such as when
you want to have specific settings for a vocal mic, you can
adjust individual settings for a program, combination, or
MIDI sequencer song.
Routing
1. In REALTIME CONTROLS, select AUDIO IN 2 and
use the SWITCH button (MIC/LINE) to specify the
input jack that you want to enable, either Mic (LED
lit) or Line (LED unlit).
If you want to save the edited settings, press "WRITE"
(MENU button) in the popup screen that appears when
you operate a switch or knob.
2. In REALTIME CONTROLS, select AUDIO IN 1 and
use the KNOB 1 knob (GAIN) to adjust the input gain
to an appropriate setting.
3. In REALTIME CONTROLS, select AUDIO IN 1 and
use the KNOB 2 knob (MFX2/REVERB) to specify
the send level to master effect 2.
For preload sounds, either a reverb-type or a delay-type
effect is assigned to master effect 2.
4. If you want to access more detailed settings, press the
FUNCTION ("QUICK SETTING" ) button in the
popup screen that appears when you operate a button
or knob in steps 1, 2, or 3.
5. Use Bus (Bus Select) to specify the bus where the
audio input will be sent. For example if you want the
output of the device that's connected to LINE IN to be
input to insert effect 1, specify IFX1 as the Bus (Bus
Select) setting when selecting the routing.
6. Use Send1 and Send2 to specify the send levels from
the input to the master effects.
These settings are available only if Bus Select is set to L/
R or Off.
If Bus Select is set to IFX1–5, the send levels to the
master effects are specified by the Send1 and Send2
parameters (in each FX ROUTING> SEND page) for the
signal that has passed through the insert effects.
Depending on the type of effects that you're using on
the external audio input, and on their settings, it is
possible for feedback to occur. If this occurs, adjust the
input/output levels and the effect settings. Take special
care when using high-gain effects.
71