Table of Contents
Advertisement
980 DP 1.4 Video Generator / Analyzer - User Guide
The following table describes the functions of the Capture Control panel.
Capture Control Panel - Function
Instrument Selection
Capture Trigger Configuration
Page 256
Item - Description
Enables you to define the capture trigger criteria. Use the
information below.
[Capture] Buffer
Enables you to set the size of the captured data
Size Slidebar
in percent. This is a slidebar that provides an
indication (on the left) of the percent of the total
possible size to be captured. A lower value will
require less time for the captured data to
accumulate.
[Capture]
Enables you to set the position of the trigger
Trigger Position
event within the captured data. This slidebar
within Buffer
determines how much of the data that has
Slidebar
accumulated in the capture buffer has occurred
before the trigger event. The slidebar has an
indication (on the left) of the location of the
trigger event within the captured data. The
value is expressed as a percent. A value of 0%
indicates that the trigger event occurs at the
beginning of the resulting captured data and
100% indicates that the trigger event occurs at
the end of the resulting captured data. A value
of 50% indicates that the trigger event is in the
middle of the captured data.
Note: The Buffer Position Slidebar is not
applicable when you select Vsync as the trigger
condition.
Trigger Mode
Enables you to specify the type of data that you
Rev. A1
June 16, 2017
Advertisement
Table of Contents
