Table of contents
8
Application....................................................................................... 345
Load encroachment characteristics.................................................351
Setting guidelines............................................................................ 357
Phase selection, quad, fixed angle, load encroachment
FDPSPDIS (21).................................................................................... 359
Identification.................................................................................... 359
Identification............................................................................... 359
Application....................................................................................... 359
Setting guidelines............................................................................ 360
High speed distance protection ZMFPDIS (21).................................... 367
Identification.................................................................................... 367
Application....................................................................................... 368
System grounding.......................................................................368
Fault infeed from remote end..................................................... 371
Load encroachment....................................................................372
Short line application.................................................................. 373
Long transmission line application..............................................374
Parallel line application with mutual coupling............................. 375
Tapped line application...............................................................382
Setting guidelines............................................................................ 384
General.......................................................................................384
Setting of zone 1.........................................................................385
Setting of overreaching zone......................................................385
Setting of reverse zone...............................................................386
Setting of zones for parallel line application............................... 387
Zone reach setting higher than minimum load impedance.........391
Other settings............................................................................. 392
ZMMMXU settings...................................................................... 395
High speed distance protection for series compensated lines
ZMFCPDIS (21).................................................................................... 396
Transformer protection RET670 2.2 ANSI
Application manual