Setting Guidelines - ABB RELION RET670 Applications Manual

1MRK 504 163-UUS A
20.3.2
20.4
20.4.1
20.4.2
Transformer protection RET670 2.2 ANSI
Application manual
IEC17000044 V1 EN-US
Figure 417: Merging unit

Setting guidelines

For information on the merging unit setting guidelines, see section
61850-9-2LE communication
Routes
Application
Setting up a route enables communication to a device that is located in another
subnetwork. Routing is used when the destination device is not in the same subnetwork
as the default gateway.
The route specifies that when a package is sent to the destination device it should be
sent through the selected router. If no route is specified the source device will not find
the destination device.
Setting guidelines
Routes are configured using the Ethernet configuration tool in PCM600.
Operation for the route can be set to On/Off by checking and unchecking the check-
box in the operation column.
Gateway specifies the address of the gateway.
Ethernet-based communication
IEC17000044-1-en.vsdx
protocol.
Section 20
GUID-3449AB24-8C9D-4D9A-BD46-5DDF59A0F8E3 v1
IEC/UCA
GUID-19616AC4-0FFD-4FF4-9198-5E33938E5ABD v1
GUID-2C4A312A-00DC-44C8-B2D9-CD0822E1C806 v1
929