Miele PW 811 Operating And Installation Instructions page 55

Water intake fault

Call Technical Service
if restart w/o success.

Check the faucet and press the "START" button.

Door lock fault

Call Technical Service
if restart w/o success.

If the door lock failure occurs again after a restart, proceed as de-

scribed in "Opening the door in an emergency". If this still cannot
be done, call Miele Technical Service.
Heating system fault

Program stop. Press Start.
Program runs with cold water.

Press the "START" button to continue the program without heating.

Tip: Disinfection programs will be cancelled if this fault message ap-
pears.
Contact Miele Technical Service.

Drive motor fault

Program stop. Press Start.
Motor temperature too high.

Allow the motor to cool down.

Too large an imbalance. The imbalance switch has been triggered.
Imbalance fault

Call Technical Service
if restart w/o success.

Turn the machine on and press "START".

Drain valve fault

Call Technical Service
if restart w/o success.

Check on-site drain system and press "START".

A defective drain valve must only be repaired by Miele Technical
Service.
Problem solving guide






55