Drain Level - Miele PW 811 Operating And Installation Instructions

Programming

29. Drain level

30. Wash time 4
31. Drainage path
2
32. Free spin
speed selection
33. Spin
144
A water level can be selected. Water can remain in the suds container
until the run-up to the spin commences. This enables optimum load
distribution during the spin and minimizes the risk of imbalance.
There is no drum rotation.
Choose from the following options:

– Water level
0 mm to Level1 or 2
Settings as for Wash time 1.
In Wash time 4 the drain is permanently open.
Settings as for drainage path 1.
Programming spin speed
Choose from the following options:

– No
The spin cycle always runs at the spin speed programmed in the
block. It is not possible to change the spin speed before the program
is started.
– Yes
The spin speed setting which was set for the last program block be-
fore a program start is carried over to corresponding program blocks.
This is independent of whether "Yes" or "No" is programmed in the
last block in the program stage under "Free spin speed selection".
Changing the spin speed before the program starts is possible.
Creating a user-defined spin profile.
Choose from the following options:

– No
No spin carried out.
– Automatic
Spin profile
Phase
Duration
Rhythm
Speed
[rpm]
– User-defined
To create a spin profile 6 different spin phases can be programmed
for each spin stage.
1 2 3
1 min. 1 min. 1 min.
No 12/3 No
500 30 500
4 5
3 min. 3 min.
No No
850 Max.
6
2 min.
12/3
30