Washing Without Detergent Compartment; Continuing Program After "Dispensing System Fault" Message; Dispensing Quantities; Commissioning The Dispenser Pumps - Miele PW 811 Operating And Installation Instructions

Washing without detergent compartment

To go directly to
Dispenser calibra-
tion when the ma-
chine is switched
off:
26
Continuing program after "Dispensing system fault"
message
If the dispensing container is empty the pump and the machine
switch off independently. At the same time the machine indicates a
lack of liquid detergent.
Dispensing system fault

Fill dispensing container ??.
Press Start.

Fill the dispenser container.

Press the "Start" button to continue the program.


Dispensing quantities

Please follow the detergent manufacturer's instructions.
Always follow the instructions of the chemical manufacturer when
using cleaning agents and special application chemicals. Only use
such chemicals for the purpose and in the situation specified by
the manufacturer in order to avoid the danger of adverse chemical
reactions and material damage.
Correct dosage also depends on the viscosity of the liquid detergent.
It should therefore be allowed to settle to room temperature before
being used.

Commissioning the dispenser pumps

Before the liquid dispenser pumps can be used the liquid detergent
must be drawn into the system and the set amount to be dispensed.

Dispenser calibration

Dispenser calibration is used to measure the throughput of individual
dispenser pumps.
Press and hold multifunction button 2 and switch the machine on

using Power On .
Dispensing calibration
Dispensing pump 1
Dispensing pump 2
Options:
– Dispenser pump 1 to 13
Select a dispenser pump.

When a dispenser pump is selected, the following will appear in the
display:
Main menu



