Change V-Belt - Holzmann TS 250F-1600 User Manual

• Safety cover back on.
• Saw blade protection cover back on.
Installation is in the reverse order of removal.
NOTE: Observe direction of rotation of the saw blade during installation!
15.2

Change V-belt

Disconnect the machine from the power supply prior to any checks performed
at the machine itself !
• Set the saw blade to tilt 90°.
• Remove saw blade - see 8.1
• 3 Allen screws M8x18 Unscrew the cover plate.
To remove the lower two Allen screws that tilt the blade to 30° is set. For the upper
NOTE:
hex screws tend to 90.degree.
• Unscrew the left side panel plate.
• Motor screws (A), loosen the extent that the belt tension to the extent laid remove the belt
around it (B).
• Remove the V-belt and replace with new.
In reverse order tension V-belt, motor tighten,
then tighten the V-belt cover and mount the saw
blade.
HOLZMANN Maschinen Austria
Fig. 22
Fig. 23
www.holzmann-maschinen.at
B
Formátovací pila / panel saw TS 250F-1600
A
Strana 45