Holzmann TS 250F-1600 User Manual page 42

Cross-cutting small plates
Adjustment of the loss, as well as guide the
workpiece through the rip fence.
Use a push stick.
Cross-cutting of long plates
Setting the target width on the mi-
ter gauge.
Tilt stop at the desired level fix.
Workpiece secured with hold-down
Feed with sliding table
Alternatively, with angle stop in position 90 °
Workpiece secured with hold-down
No resting on table boom
Preferable variant depending on dimensions of
the workpiece
Cutting of large plates
Workpiece support table on boom
Side of the rip fence
Decrease in scale to the right
Miter fence (90 °) before work
Workpiece fixation with retention
cutting boards
Miter fence behind workpiece
Lateral fixation with tilt stop
Workpiece fixation by means of
retainers
HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Formátovací pila / panel saw TS 250F-1600
Strana 42