Operation; Adjustments Before Initial; Saw Blade Start / Stop; Setting The Cutting Length - Holzmann TS 250F-1600 User Manual

14

OPERATION

14.1

Adjustments before initial

+ Before any adjustments, the machine must be disconnected from the power supply to avoid
the risk of accidental switching on the machine!
+ Check that the set speed for the saw blade used is not too high.
+ Span only saw blades with a diameter of 254 mm.
14.2 Operation

14.2.1 Saw blade start / stop

If you want to press the ON OFF switch, the combined
EMERGENCY STOP switch must be in the open state.
•
To start, press the green button ˝ I ˝
•
To start, press the red button ˝ O ˝
INFO: In the closed state of the main switch can be operated as an EMERGENCY STOP switch.
14.2.2

Setting the cutting length

The cutting length can be set on the rip fence guide so that it is read on the graduated
With the clamping screw, this
14.2.3

Saw blade height adjustment

To adjust the height of the material of the blade, turn the handwheel A (Fig. 20) clockwise
around the blade upward to lift. Turn to lower it to the left.
The blade should protrude approximately 5 mm from the workpiece.
After adjusting the height with the clamp screw / lever clamp
HOLZMANN Maschinen Austria
can be fixed. (Fig. 9)
A
www.holzmann-maschinen.at
B
Fig. 21
Formátovací pila / panel saw TS 250F-1600
scale.
Strana 40