Install Guide Rail And Rip Fence; Mounted Handwheel Height Adjustment / Tilt Angle - Holzmann TS 250F-1600 User Manual

d) rear worktable screw (Fig. 6)
• With 2 screws M8x12 and washers rear worktop is bolted to the
main work

13.2.2 Install guide rail and rip fence

• Install guide rail and rip fence
• Set 3 pcs 4-kant M8x25 screws from the outside into the worktop. (Fig. 7)
• Inside turn to screw on the screws washers and 6-hexagon nuts.
• Slide the guide rail as shown on Fig.7 with the profile on the screws.
• The 6-hexagon nuts tighten slightly.
• The guide rail ausjustieren and tighten securely.
13.2.3 Mounted handwheel height adjustment /
tilt angle
The hand wheel for height adjustment (1) and for the Incli-
nation angle (2) Place the blade onto the shaft and tighten
with the appropriate screws on the spindle shaft
HOLZMANN Maschinen Austria www.holzmann-maschinen.at
Fig. 6
Fig. 7
4-hexagon screw
Guide rail rip fence
1
Fig. 8
Formátovací pila / panel saw TS 250F-1600
2
Strana 35