Sliding Table Mount And Align - Holzmann TS 250F-1600 User Manual

Table of Contents

Advertisement

Available languages

Available languages

f)
Align
assembly rip fence rail / measuring scale
• Adjust the tilt angle of the saw blade to 90 °.
• Slide the rip fence to the rip fence rail.
• The rip fence to the saw blade slide.
• Tap on the right end of the scale to the "0" scale on the
rail with the red line on the Lens align the rip fence.
g) Cultivation of the rocker arm
• Place the rocker arm on the base unit and fasten with
4 screws M8x30

13.2.4 Sliding table mount and align

• Insert the angle brackets with the mounted 6-hexagon
screws heads (B) in the T-slot (A) of the basic profile.
• Slightly tighten the angle brackets with washers and
6-hexagonal screws.
• Adjust the gap at the left end of the sliding table to the
base frame of 400mm. (Fig. 12)
• Set the distance from the sliding table to the main table
to 2-3 mm parallel to the saw blade.
• With the adjustment screws (E) set horizontally on both
sides and tighten lock nut. (Fig. 13)
• Tighten the M10 nuts (D). (Fig. 13)
HOLZMANN Maschinen Austria
Fig. 12
www.holzmann-maschinen.at
Fig. 10
Fig. 11
Formátovací pila / panel saw TS 250F-1600
Fig. 9
Strana 36

Advertisement

Table of Contents
loading

Table of Contents