Adjust The Riving Knife; Electrical Connection; Earthing Connection; Formátovací Pila / Panel Saw Ts 250F - Holzmann TS 250F-1600 User Manual

13.2.11

Adjust the riving knife

The splitting wedge is dimensioned so that it is thicker than
the blade in its width. This ver-prevents that the teeth on
the rear periphery of the saw blade does not contact the
workpiece and it is damaged accidentally, or can be thrown
out.
• Set the distance of the gap wedge to blade ready to
approx. 3 - 8mm
• Unscrew the screws on the splitting wedge slightly and
tighten it again after adjustment.
This procedure
NOTE:
13.3

Electrical connection

Only a qualified electrician is authorized for the electrical connection, including the installation of
the supply part. This must be cut off before the electrical connection. Only when the main power
supply is cut off, each contact can be closed. The cowl box is attached to the back of the machine
body. There is also a junction box on the side, which you have to connect only to the marking.
13.4

Earthing connection

When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Machine must be grounded and be connected to a grounded outlet
ρ
+ The electrical connection of the machine is ready for operation on a grounded electrical outlet!
+ The plug must be connected only to a properly fitted and grounded electrical outlet!
+ The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
+ The grounding conductor is green-yellow!
+ In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
+ Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
+ A damaged cable must be replaced immediately!
HOLZMANN Maschinen Austria
should be repeated each time the when the saw blade is
Therefore:
www.holzmann-maschinen.at
A T T E N T I O N
Formátovací pila / panel saw TS 250F-1600
replaced.
Strana 39