Assembly Of The Base Frame - Holzmann TS 250F-1600 User Manual

13.2
assembly
The sliding table saw is delivered pre-assembled. Base-frame, Side work table, rear work table,
rip fence, miter gauge, riving knife and blade guard must be fitted.

13.2.1 Assembly of the base frame

Remove the side panels and the four angles of the packaging.
Following the end, refer also:
16 pcs 6 hexagon screws M8x16, 32 St. washers 8mm, 16 pcs M8 nuts.
a) Assemble the base frame as shown (Fig. 3)
Fig. 3
The following can be found also:
4 pcs 6 hexagon screws M8x16mm, 8 pcs 8mm flat washers, 4 St. M8 nuts.
• Open the side door with the star knob screw.
b) The machine unit to the base frame mount (Fig. 4)
c) lateral worktable screw (Fig. 5)
• With 4 screws M8x22 and washers lateral worktop is bolted to the main work surface.
HOLZMANN Maschinen Austria
Fig. 5
www.holzmann-maschinen.at
Fig. 4
Formátovací pila / panel saw TS 250F-1600
Strana 34