Install Sliding Table Support; Screw The Sliding Table Handle And Locking Pin; Install Sliding Table Extension - Holzmann TS 250F-1600 User Manual

• The two nuts (D) firmly.
• The angle brackets using the 4 screws (F)
tighten.
13.2.5

Install sliding table support

• Insert the T-bolt with the bracket in the basic profile of the
sliding table and tighten by turning the prop. (Fig. 14)
13.2.6 Screw the sliding table handle and lo-
cking pin
• The T-nut M12x1,75 push in the slide profile.
• The handle and tighten with a wrench SW17.
• Install the locking bolt bracket with 2 screws
M6x10

13.2.7 Install Sliding table extension

• Slide two M12x55 T type bolts into the slot of
the sliding carrier, let the crosscut table attach to
the sliding panel.
• Place the cross-cut table (A) onto the swing arm
assembly and install it on the M20 screw.
• Use two ratchet handle mounted the cross-cut
table to sliding panel.
• Adjust the thin two nuts M16 (B) to adjust the
cross cut table on the line with sliding panel.
• Then tighten the two thin nuts M16 (B) and the
thin nut M20 (C).
HOLZMANN Maschinen Austria
Fig. 13
www.holzmann-maschinen.at
D E
Fig. 15
clamping lever
C
B
Formátovací pila / panel saw TS 250F-1600
F
Fig. 14
Fig. 16
Strana 37