Setting Angle Of Intersection; Sectional Variations - Holzmann TS 250F-1600 User Manual

14.2.4

Setting angle of intersection

The handwheel B (Fig. 21) serves the incline of the saw blade from
90 ° set at 45 °.
14.3

sectional variations

Longitudinal sections, long sections
Here's to accomplish through the rip fence the side guide.
In blanks with a width of less than 120 mm for feeding the work-
piece MANDATORY ON SLIDING STOCK TO USE!
Cross sections, short sections
For this purpose, the angle-adjustable miter gauge to be used.
Bring these In the position 90 ° to the saw blade and place the workpiece thereon on.Supportive
can, for example, be used for repeated cutting at the same width, the rip fence as an additional
lateral support.
Cuts at an angle
For this purpose, the angle-adjustable miter gauge to be used.
Bring these to the desired angle to the saw blade and place the workpiece thereon
to Note
Before each use to make sure the proper state of the
That in particular: Blade
wedge min. Tightened 3mm distance from the saw blade
al, all connections and stable etc ...
edging shoe
The edging shoe serves to avoid a workpiece kickback.
Longitudinal cutting of plates
Setting the acceptance by scale miter on.
Workpiece support table on boom and fixation with
retention.
Feed with sliding table.
Use with decreasing width under 120mm disc Stock
HOLZMANN Maschinen Austria
sharpened and without cracks or other damage
www.holzmann-maschinen.at
Sliding stock
machine!
(injury !!!),
teeth, EMERGENCY OFF switch function-
Formátovací pila / panel saw TS 250F-1600
on.
splitting
Strana 41