Saw Blade Change - Holzmann TS 250F User Manual

15.1

saw blade change

CAUTION:
When installing saw blade change and always use protective gloves !
 The saw blade to max. Adjust the height.
 The 8 screws on the table insert Unscrew and remove the table insert.
 Fix the blade on the flange with the round pin with button.
 The bolt with a wrench from the shaft screws.
 Clean the motor spindle and flange thoroughly of impurities.
 Insert the blade with the correct direction of rotation on the motor spindle.
 Place the cleaned flange to the motor shaft.
 Screw the screw with washer back into the shaft and with wrench and round pin with button
-against turning sichern- tighten again.
NOTE: Observe direction of rotation arrow on the saw blade.
 Table insert reinsert and tighten the screws.
15.1.1 Cleaning
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therefore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40 )
15.1.2 Disposal
Do not dispose of the TS 250F in residual waste. Contact your local authorities for in-
formation regarding the available disposal options. When you buy at your local deal-
er for a replacement unit, the latter is obliged to exchange your old
HOLZMANN Maschinen Austria
Table insert
for using wrench
www.holzmann-maschinen.at
Round pin with button
N O T E
Strana 41
Formátovací pila / Panel saw TS 250F