Install The Cross-Cut Fence; Screw The Suction Hose Adapter; Screw Blade Guard Cover - Holzmann TS 250F-1600 User Manual

13.2.8

Install the cross-cut fence

• Drop the cross cut fence into the forward or
rear guide pin hole.
• Tighten the knurled nut.
• Turn the star type screw and clamped the fence
in position.
• Slide the flip stop (A) into the fence.
• Place a T-nut into the top slot of fence, thread
the stud of hold-down on fence.

13.2.9 Screw the suction hose adapter

• Screw the suction adapter with 4 screws M6x12 and
washers

13.2.10 Screw blade guard cover

•
Screw the blade guard cover on the riving knife
HOLZMANN Maschinen Austria
Fig. 17
www.holzmann-maschinen.at
Fig. 18
Fig. 19
Formátovací pila / panel saw TS 250F-1600
Strana 38