Installation Of The Rip Fence Rail - Holzmann TS 250F User Manual

Now mount the extra table with the slots in the eight screws.
Tighten the eight screws, keep in mind that the extra table is mounted at the same height as the
main table.
NOTE: Raise the table never without help! Always pay attention to the correct lifting posture!
12.2.9

Installation of the rip fence rail

To install the rip fence rail requires the following:
Four M8x25 screws, four washers 8mm, Four M8 self-locking
nuts
Screw the rail acc. The following diagram on the main table
firmly, making sure that the track runs parallel with the ta-
ble.
12.2.10 Assembly of the rip fence
The handle clockwise to the holder screw.
The holder and the ruler with two allen screws M8-12 screw.
The rip fence is now being used in the stop rail.
If the ruler does not slide smoothly, the stop rail can be ad-
justed.
The rip fence can be fixed at the desired position by a lever
movement downwards.
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Strana 35
Formátovací pila / Panel saw TS 250F