How To Install And Remove - PRIMERGY BX600 S2 Hardware Manual

■ Server blades installation points
When the server blade is installed to the server blade slot, the LAN port of the server blade is connected
to each port of the Switch Blade through the middle plain in the chassis. Decide the slot to which to
install the server blade according to the network configuration.
For more details, refer to "4.2.3 LAN Connection in the Chassis" ( pg.40).
The server blade slot numbers are indicated below.
If the Switch Blades or GbE Pass-Thru Blades that correspond with the various ports of the server
blade are not installed, the port cannot be used.

4.2.2 How to Install and Remove

■ How to remove server blades
1
Turn off the server blade.
Turn off the server blade you wish to remove.
"3.3 Turning Off the Server" (pg.26)
2
Touch a metal part of the chassis to discharge static electricity.
3
Remove all cables etc. connected to the server blade.
Remove the display/USB cables connected to the server blade you wish to remove, as well as
cables connected to the expansion card slot module.
PRIMERGY BX600 S2 Blade Server System Unit Hardware Guide
1 2 3 4 5 6 7 8 9 10
4
37