Choosing Your Mobile Broadband Provider Manually - NetComm NTC-6908 User Manual

UMTS 900
WCDMA A
UMTS 900
2G
ALL BAND
Click Save to confirm the n
NOTE: A After changing the ba
Ch hoosing Yo our Mobile
The default setting is "Au utomatic".
To s can manually for ava ailable cellular networ
1. If you are currently y connected to the in
by clicking on the "Internet Settings" m
2. Set the operator m mode to Manual
3. Click on the Scan button. A list of cellu
4. Select your chose en provider from the l
The router will then use th he chosen operator t
YML L6908
www w.netcommwireless.c com
23
BAND SELE ECTION OPTIONS
0Mhz Only UMTS 900 0 MHz Only
All UMTS 900/2 2100/1900MHz
0MHz, 2G UMTS 900 M MHz GSM/EDGE/GPRS 85
GSM/EDGE E/GPRS 850/900/1800/1900
DS (AUTOBAND) UMTS 850 0/900/2100/1900MHz GSM
Table 7: NTC‐690 09 Band Selection O
new band settings.
nd, if the change is n not reflected on the fr requency field on the
Broadban d Provider r Manually
rk operators (provide ers) follow the steps b below:
nternet, disconnect yo our session and ensu ure "Auto Connect" is
menu and selecting "m mobile broadband" fo ollowed by the "Conn
ular operators in the v vicinity of your router should appear unde
ist of detected opera ators and click the Ap pply button
to attempt to connect t to the cellular servic ce profile you have e
Figure 31: Select ting a Band Manual
– NTC-6909
50/900/1800/1900MHz
0MHz
M/EDGE/GPRS
Options
e "Status" page then you may need to reb
s disabled in the curr rent cellular connectio
nection" menu item).
er the "Operator Nam e List" heading.
lected to use.
lly
boot the router.
on profile you are us ing (You can check t this
NTC-6000 Series U User Guide