Internet Settings; Mobile Broadband (Mbb) - NetComm 4G100W User Manual

Internet Settings

Mobile Broadband (MBB)

Connection
This page allows you to setup your Mobile Broadband (MBB) connection. There are four connection profiles that may be configured
on the device. All profiles are disabled by default, except for Profile1 which is the automatically configured profile. The automatically
configured profile tries to connect automatically based on information which is detected by the SIM card that is inserted into the
device.
To configure a particular profile, select it from the dropdown menu labelled "Profile Name". Each profile can be configured
independently. To enable/disable each individual profile, please select it from the dropdown list, and configure "Auto Connect" to be
either enabled or disabled. In order to enable a profile, any other profiles which are enabled must first be disabled.
OPTION
Profile Name
APN Name
Mobile Broadband Connection
Username
Password
Authentication Type
Reconnect Delay
Reconnect Retries
Metric
MTU
NAT Masquerading
Data Roaming
4G LTE WiFi Router
17
Figure 9 - Advanced View – WWAN Settings
A descriptive name to identify the Mobile Broadband (MBB) profile and associated settings.
Enter the APN name you wish to connect to in this field. Please do not edit this field unless you are aware of
what effect it will have. You can use the drop down box to select your country and then move your mouse over
"Choose an APN here" to select an APN from the list stored on the router.
Select to enable or disable this mobile broadband profile.
The username supplied by your MBB provider in order to connect to the MBB service (if applicable).
The password supplied by your MBB provider in order to connect to the MBB service (if applicable).
The type of authentication in use by the MBB network. For more information, please contact your MBB
provider.
The delay in seconds between attempts to reconnect to the MBB service.
The number of reconnection attempts that will be made to the MBB service. Setting this to 0 configures the
router to attempt to reconnect until a connection is re-established.
This field allows you to customize the metric of the MBB interface. This setting will have no effect for most
users, but may be required for advanced routing configurations (Static Routes, RIP, VPN, etc)
Maximum Transmission Unit. Do not modify this value unless you aware of the effect it will have or instructed to
by your service provider.
Enabled by Default, this option allows you to switch NAT (Network Address Translation) on or off.
Select to enable data roaming for your SIM card.
Table 11 - Advanced View - Internet Settings
DEFINITION
YMLN4G100W
www.netcommwireless.com