NetComm NTC-6908 User Manual page 62

Lo ocal Firmwa are Upgrad
The firmware update pro cess has two steps.
You can do this by clickin ng on the browse bu
Onc e you have selected the system recovery
the s status bar reaches 10 00% and the "Phase:
Whe en the upload has com mpleted, the screen
Onc e you see "Done" sh own as per the scree
Pres ss and hold the reset button for approxima
the s system recovery mod de.
NTC C-6000 Series – Indus strial M2M Wireless R
62
www w.netcommwireless.c com
de
The first step is to up pload and install the s system recovery ima
tton and then to navi gate to where the rec covery image upgrad
Figure 76: System m ‐ Load/Save ‐ Upl
y image file to use, cli ck Upload to upload d the file. You will then
:" has changed to Co omplete.
Figure 77: System m ‐ Load/Save ‐ Firm
should refresh and li st the system recove ery file you have just u
Figure 78: Firmw ware Install Link
enshot below, you ca an then boot into the s system recovery mod
Figure 79: Firmw ware Upgrade Done
ately 5 – 10 seconds until the LEDs on the e front of the router st
Routers
NETCOMM CALLDIRECT™ SERIES – NTC
ge onto the router.
de file is located on y your computer.
load
n see a progress bar r as shown in the scre
mware Upgrade Pro ocess
uploaded. Click on th he "Install" link to the
de to install the main system software.
Message
tart to flash in an ON / OFF sequence and
C-6000 Serie s
eenshot below. The u upload has finished w when
right of this.
d then release it. The router will now boot
YML6908
into