NetComm NTC-6908 User Manual page 42

How w to Configure t the Periodic Pin
This facility is available b by clicking on the "Se
The Periodic Ping Reset Monitor configures th
will r reboot.
This works as follows:
1. After every "Period dic Ping Timer" confi
2. If all 3 pings fail th he router sends 3 con
3. The router then se ends 3 consecutive p
4. If all accelerated p pings in step C above
5. If any ping succ eeds the router retur
Note: The " Periodic Ping Timer"
NTC C-6000 Series – Indus strial M2M Wireless R
42
www w.netcommwireless.c com
g Reset Monitor r
ervices" menu followe ed by the "System Mo onitor" menu item on
he router to transmit c controlled ping packe kets to 1 or 2 user spe
gured interval, the ro outer sends 3 consec cutive pings to the "D
nsecutive pings to the e "Second Address". .
pings to the "Destinat ion Address" and 3 c consecutive pings to
e fail the number of t imes configured in "F Fail Count", the route
rns to step 1 and doe s not reboot.
should never be set to a value less than 60 seconds; this is to
Routers
NETCOMM CALLDIRECT™ SERIES – NTC
the right.
ecified IP addresses. Should the router no
Figure 5 7: Services ‐ System m Monitor
Destination Address".
the "Second Addres ss" every "Periodic Pi
er reboots.
o allow the router tim e to reconnect to the
C-6000 Serie s
ot receive responses to the pings, the rou uter
ing Accelerated Time er" configured interva al.
e cellular network follo owing a reboot.
YML6908