Stihl TS 440 Instruction Manual page 21

when the operator attempts to move the
machine in a sideways direction, and
can result in loss of control.
Maintenance, Repair and Storing of the
Cut-Off Machine
Never operate a cut-off machine that is
damaged, improperly adjusted or not
completely or properly assembled.
Follow the maintenance and repair
instructions in the appropriate sections
of this instruction manual.
WARNING
STIHL recommends the use of only
STIHL replacement parts for
maintenance and repair. Use of parts
manufactured by others may be
extremely dangerous and could result in
serious or fatal injury.
WARNING
Always shut off the machine and make
sure that the wheel is stopped before
doing any maintenance or repair work or
cleaning the cut-off machine. When the
machine is shut off, the wheel continues
to rotate for a few seconds before the
brake engages. Do not attempt any
maintenance or repair work not
described in this manual as appropriate
for users. STIHL recommends that you
have all other work performed at your
authorized STIHL servicing dealer.
Clean off dust and other cutting debris
after finishing work. Check and, if
necessary, tighten all nuts, bolts and
screws except the carburetor
adjustment screws after each use.
TS 440
Do not clean your machine with a
pressure washer. The solid jet of water
may damage the machine or its
components.
WARNING
Never test the ignition system with the
spark plug boot removed from the spark
plug or with an unseated spark plug,
since uncontained sparking may cause
a fire.
WARNING
To reduce the risk of fire and burn injury
or property damage, use only spark
plugs authorized by STIHL. Always
press the spark plug boot snugly onto
the spark plug terminal of the proper
size. A loose connection between the
spark plug terminal and the ignition wire
connector in the boot may create arcing
that could ignite combustible fumes and
cause a fire. Keep the spark plug clean,
and make sure the ignition lead is in
good condition. Do not use a spark plug
with a detachable SAE adapter terminal.
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
WARNING
Do not operate your cut-off machine if
the muffler is damaged, missing or
modified. An improperly maintained
muffler will increase the risk of fire and
hearing loss. Never touch a hot muffler
or spill fuel or other flammable liquid
over it. Your muffler is equipped with a
spark-arresting screen to reduce the risk
of fire. Never operate your cut-off
machine if the screen is missing or
damaged.
WARNING
Operation of this equipment may create
sparks that can start fires around dry
vegetation. A spark arrester is required.
The operator should contact local fire
agencies for laws or regulations relating
to fire prevention requirements.
In California, it is a violation of § 4442 or
§ 4443 of the Public Resources Code to
use or operate gasoline-powered tools
on forest-covered, brush-covered or
grass-covered land unless the engine's
exhaust system is equipped with a
complying spark arrester that is
maintained in effective working order.
The owner/operator of this product is
responsible for properly maintaining the
spark arrester. Other states or
governmental entities/agencies, such as
the U.S. Forest Service, may have
similar or additional requirements.
Contact your local fire agency or forest
service for the laws or regulations
relating to fire protection requirements.
Even if the spark arrester is in place, it
may not be advisable to use gasoline-
powered equipment, including cut-off
machines, in hot, dry conditions or
around dry vegetation or brush. Contact
your local fire authorities or the U.S.
Forest Service if you have any question
about whether conditions are suitable for
the use of a cut-off machine.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of this manual.
English
19