Settings For Otdr Tests - Fluke OF-500-10 Technical Reference Handbook

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook

Settings for OTDR Tests

Table 3-1 describes the settings that apply to OTDR tests.
SETUP Tab Setting
Job tab Job settings
Cable tab FIBER TYPE
3-10
Table 3-1. Settings for OTDR Tests
Before you run a test you will save, you may want to set the job, fiber ID, and
cabling end information. These settings are saved with test results to identify the
job site, the cabling tested, and the test direction. See Chapter 2 foGr details.
Select a fiber type that is appropriate for the type you will test. You can select
factory-installed fiber types or custom types, which you configure with the Edit
Custom Test Limit function in FUNCTIONS. See Chapter 10 for information on
creating custom fiber types.
Select a fiber type before selecting a test limit. The fiber type determines
which test limits are available.
Description
Note
-continued-