Finding Connections with FindFiber
The FindFiber function is available with the loss/length
test option. This function helps you trace connections at
patch panels and quickly check fiber continuity.
The FindFiber function is not available in Far End
Source mode.
A
Tester with OFTM-5612B or OFTM-5732 module and
smart remote (DTX remote shown). Match connector
adapters to the connectors in the link.
B
Spare battery pack (optional)
C
Two ac adapters with line cords (optional)
Note
Figure 6-14. Equipment for Using FindFiber in Smart Remote Mode
Using the Loss/Length Option
Finding Connections with FindFiber
Using FindFiber in Smart Remote Mode
Use FindFiber in Smart Remote mode to help you
determine which fibers go to which connectors at a patch
panel.
Figure 6-14 shows the equipment needed for using
FindFiber in Smart Remote mode.
D
Two duplex reference test cords. Match the fiber to be
tested. One connector on each cord must be SC. For the
others match the connectors in the link.
E
Fiber cleaning supplies
6
ajt50f.eps
6-43