Table of Contents
Advertisement
DMX 512 Address
Press the MENU button until the
the display will blink. Use DOWN and UP button to change the DMX 512 Address. Once the
address has been selected, press ENTER button to setup or automatically exit menu mode without
any change after one minute. Back to the previous functions without any change press MENU
button.
Auto DMX Address setting
Press the MENU button until the
the DMX address of the fixture can be set automatically by built‐in program. To go back to the
functions press the MENU button again.
Channel Mode
Press the MENU button until the
the display will blink. Use DOWN and UP button to select the
(3 channels mode) or
channels mode) or
to setup or automatically exit menu mode without any change after one minute. To go back to the
functions without any change press the MENU button.
Note: In RC8 mode, the fixture will run the effect in RC8 controller.
Show Mode
Press the MENU button until the
DOWN and UP button to select the
or ... or
(show 12). If you select the show mode, press ENTER button to confirm, and use
DOWN and UP button to select
Once select, press ENTER button to setup or automatically exit menu mode without any change
after one minute. To go back to the last function without any change press the MENU button.
is shown on the display. Pressing ENTER button and
is blinking on the display. Pressing ENTER button and
is shown on the display. Pressing ENTER button and
(6 channels mode) or
(RC8 mode). Once the mode has been selected, press the ENTER button
is shown on the display. Pressing ENTER button, Use
(Random show) or
(speed 1: the slowest) or...or
(4 channels mode) or
7A
(4 channels mode) or
(4
(show 1) or
(speed 8, the fastest).
(Show 2)
Advertisement
Table of Contents
