Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ACME Ellipsoidal 10 DMX
Summary of Contents for ACME Ellipsoidal 10 DMX
-
Page 2: Specifications
Features: E-10D/E-40D is DMX Version, uniform light, sharp image edge, and self-locking focus lens. The product takes advantage of the heat pipe heat conduction and housing feature to dissipate heat without fan to prolong LED life. Specifications: Power Voltage: AC 100~240V, 50/60Hz ... - Page 3 How To Change The Gobo At first, put the gobo by hand as the arrow into the gobo gel splint, and insert the gobo gel splint into the slot of the unit, please turn the hand knob to left or right in order to take out gobo gel splint. Note: The diameter of the inner and outer rings of the gobo, the size and thickness of the gobo gel splint are shown in the following figure: How To Change The Focus Lens...
-
Page 4: Main Function
At first, please push the screws on both side of the fixture by hand as the arrow, and move away the focus lens silently by hand as the arrow. Then insert the focus lens as the arrow silently, and insert the screws in place by hand as the arrow, and fasten the lens. - Page 5 DMX Address Channel Mode DMX State MENU Dimmer Mode Display Inversion Manual Mode Auto Test Fixture Hours Software Version DMX Address Press the MENU button up to when the is shown on the display. Press the ENTER button and the display will blink. Use the DOWN and UP button to change the value from 1 to 512.
- Page 6 Channel Mode Press the MENU button to show on the display. Press the ENTER button and the display will blink. Use the DOWN and UP button to select 1ch or 2ch. Once the mode has been selected, press the ENTER button to setup, to go back to the functions without any change press the MENU button again.
- Page 7 press the ENTER button to setup, to go back to the functions without any change press the MENU button again. Hold and press the MENU button about one second or wait for one minute to exit the menu mode. Mode 1(Optically Linear): The increase in light intensity appears to be linear as DMX value is increased.
- Page 8 selected, press the ENTER button to setup, to go back to the functions without any change press the MENU button again. Hold and press the MENU button about one second or wait for one minute to exit the menu mode. Display Inversion Press the MENU button until is blinking on the display.
-
Page 9: Dmx Controller
Auto Test Press the MENU button up to when the is blinking on the display. Press the ENTER button and the unit will run the built-in programmer for self-test. To go back to the functions press the MENU button. Fixture Hours Press the MENU button up to when the is blinking on the display. -
Page 10: Dmx512 Configuration
functions without any change press the MENU button again. Hold and press the MENU button about one second or wait for one minute to exit the menu mode. Please refer to the following diagram to address your DMX512 channel for the first 4 units: Unit 1 Unit 2... -
Page 11: Troubleshooting
DIMMER FINE 000-255 0%~100% Troubleshooting The fixture does not work, no light 1. Check the connection of power and main fuse. 2. Measure the mains voltage on the main connector. Fixture Cleansing The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. - Page 12 Declaration of Conformity We declare that our products (lighting equipments) comply with the following specification and bears CE mark in accordance with the provision of the Electromagnetic Compatibility (EMC) Directive 2014/30/EU. EN 55032: 2015; EN 61000-3-2: 2014; EN 61000-3-3: 2013; EN 55103-2: 2009. &...