GE N60 Instruction Manual page 560

TARGETS MENU
• Description of problem: A firmware upgrade operation was attempted while the lock relay setting was enabled.
• What to do: Ask the Supervisor to unlock the relay and try again.
SETTING LOCK
• Message: "Unauthorized setting write"
• Latched target message: No.
• Description of problem: A setting write was attempted while the lock relay setting was enabled.
• What to do: Ask the Supervisor to unlock the settings and try again.
SERVER UNAVAILABLE
• Message: "An attempt to contact the Radius server has failed"
• Latched target message: No.
• Description of problem: The RADIUS authentication server is unavailable.
• What to do: Verify network connectivity and try again.
DOS PARTITION ALARM:
SELF-TEST ERROR
• Description of problem: There is a problem with the Compact Flash memory in the CPU module.
• How often the test is performed: On relay power-up and afterwards once every 24 hours.
• What to do: Contact the factory.
PROTOTYPE FIRMWARE:
Self Test Error
• Description of problem: Seen until the builds is tagged as being 'release candidate' or 'gold' builds.
• What to do: Update firmware to either of these builds.
•
7.2.2.4 HardFiber major self-test error messages
In addition to those provided by the standard UR-series devices, the UR devices implement HardFiber self-tests. These are
7
listed here. Any abnormal diagnostic condition indicated by the LEDs or the critical failure relay also results in a self-test
message, so troubleshooting is described here. For other relays, such at the B95
EQUIPMENT MISMATCH
• Description of problem: The number or type of installed hardware modules does not match the order code stored in
the CPU. The standard UR-series Equipment Mismatch self-test is extended to cover the possible presence of a
Process Card.
• Severity: Protection is not available and all contact outputs and shared outputs are de-asserted.
• What to do: Check all modules against the order code. Ensure they are inserted properly, and cycle the control power.
If a module has intentionally been added or removed use the Update Order Code command to notify the relay that the
current module configuration is correct.
MODULE FAILURE
• Description of problem: UR-series device module hardware failure detected.
• Severity: Protection is not available and all contact outputs and shared outputs are de-asserted.
7-14 N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 7: COMMANDS AND TARGETS
Plus
, see that product's instruction manual.