Security; Targets Menu; Target Messages - GE N60 Instruction Manual

CHAPTER 7: COMMANDS AND TARGETS

7.1.6 Security

COMMANDS  SECURITY
 SECURITY

With the CyberSentry option, this setting is available to enable or disable the following commands.
— Selecting 'Yes' allows the Supervisor to forcefully logoff an administrator session.
ADMINISTRATOR LOGOFF
— Selecting 'Yes' allows the Supervisor to forcefully logoff an engineer session.
ENGINEER LOGOFF
— Selecting 'Yes' allows the Supervisor to forcefully logoff an operator session.
OPERATOR LOGOFF
— Selecting 'Yes' allows the Supervisor to forcefully clear all the security logs and clears all the
CLEAR SECURITY DATA
operands associated with the self-tests.

7.2 Targets menu

A target enables the EnerVista UR Setup software to monitor automatically and display the status of any active target
messages of all the devices inserted into that site.
Each N60 element with a TARGET setting has a target message that when activated by its element is displayed in
sequence with any other currently active target messages in the
and Digital Element 48 target settings are active and so have their targets displayed. The down arrow below the two
elements indicates that there can be other active elements beyond these two.
For more information, see the description of target messages in the next section, and the Introduction to Elements section
in the Settings chapter for instructions on TARGET setting.
When no targets are active, the display reads

7.2.1 Target messages

When there are no active targets, the first target to become active causes the display to immediately default to that
message. If there are active targets and the user is navigating through other messages, and when the default message
timer times out (i.e. the keypad has not been used for a determined period of time), the display again defaults back to the
target message.
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
ADMINISTRATOR

LOGOFF: No
ENGINEER

LOGOFF: No
OPERATOR

LOGOFF: No
CLEAR SECURITY DATA:

No
TARGETS

PHASE TOC4

OP: A B -
DIGITAL ELEMENT 48:

LATCHED


NO ACTIVE TARGETS
Range: Yes, No
Range: Yes, No
Range: Yes, No
Range: Yes, No
Displayed only if targets for this element are active.
Example shown.
Displayed only if targets for this element are active.
Example shown.
menu. In the example shown, the Phase TOC4
TARGETS
.
TARGETS MENU
7
7-7