GE N60 Instruction Manual page 288
Network stability and
synchrophasor
Hide thumbs
Also See for N60:
- Instruction manual (644 pages) ,
- Communications manual (532 pages) ,
- Communications manual (526 pages)
Table of Contents
Advertisement
PRODUCT SETUP
Initial Setting Group
Range: 1 to 6 in steps of 1
Default: 1
The entered value sets the initial value of the non-volatile register normally controlled by the service SelectActiveSG. This
initialization occurs only on the UR reboot immediately following the receipt of a valid CID file.
5
This setting is not mapped into the IEC 61850 information model, but sets the value of SettingControl element attribute
actSG in SCL files.
Commands
The UR implements a number of clear records commands as detailed in the Commands and Targets chapter of this
manual. Several of these commands also can be issued via IEC 61850. The settings related to these IEC 61850 commands
are described here.
Navigate to Settings > Product Setup > Communications > IEC 61850 > Settings for Commands to access the settings
that configure the IEC 61850 protocol interface for record clear commands.
5-94
Figure 5-42: Setting Groups panel
Figure 5-43: Commands panel
N60 NETWORK STABILITY AND SYNCHROPHASOR MEASUREMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
Advertisement
Table of Contents
