Connecting Using A Usb Cable Without A Wireless Network (Windows Only); Resetting The Wireless Connection Setup - Brother 891-Z08 Operation Manual

Connecting Using a USB Cable
Without a Wireless Network (Windows
Only)
With a USB cable, directly connect the machine and
the computer with DesignNCut Manager
(application for selecting cut settings).
a
Turn off the machine, then, while holding down
on the operation panel, press
on the machine, and continue holding down
until you see the Machine Mode choice on
screen.
b
Press to select [USB] and enter USB mode.
c
When the following message appears, turn the
machine off, then on again.
Turn the machine off, then on
again.
When the setting is changed, the following
message appears.
Standby (USB)
d
Plug the USB cable connectors into the
corresponding USB ports on the computer and
on the machine.
e
Select [USB Cable] in the window for selecting
the connection method, and then click [Next].
The connection is finished.
Note
• When connecting the machine and computer
with a USB cable, the AutoPlay dialog box may
appear repeatedly. To not display the dialog
box, change the AutoPlay settings as described
below.
-
-
to turn
-
Resetting the Wireless Connection
Setup
a
From the [DesignNCut] menu, click [Network
reset for DesignNCut].
Memo
• With the mobile device version:
b
Click [OK] to begin initializing.
• Follow the on-screen instructions to complete the
operation.
• See "Selecting the Connection Method" on
page 12 to connect to a wireless network.
Windows 7
Click > [Control Panel] > [Hardware and
Sound] > [AutoPlay]. Uncheck [Use AutoPlay
for all media and devices], then click [Save]
to apply the settings.
Windows 8.1
Move your mouse to the lower right corner
of your desktop. When the menu bar
appears, click [Settings] > [Control Panel] >
[Hardware and Sound] > [AutoPlay]. Select
[Take no action] from the [Removable drive]
drop-down list, then click [Save] to apply the
settings.
Windows 10
Click > [Windows System] > [Control
Panel] > [Hardware and Sound] > [AutoPlay].
Select [Take no action] from the [Removable
drive] drop-down list, then click [Save] to
apply the settings.
→[Network reset for DesignNCut].
1
17