Table of Contents
Advertisement
Error Code
(Cutting
Error Messages (DesignNCut Manager)
Machine)
E507
Not connected to a network.
E508
Wireless LAN connection failed.
E510
Failed to search a machine.
E512
Failed to connect to server.
Failed to connect to server.
E513
Confirm proxy settings.
An error occurred while connecting to
E514
ScanNCutCanvas.
Connecting to ScanNCutCanvas failed.
E518
Register the login ID for ScanNCutCanvas
again.
Connecting to ScanNCutCanvas failed.
E519
Register the login ID for ScanNCutCanvas
again.
Cannot connect to machine.
E527
Select an appropriate connecting mode for
the settings on DesignNCut.
E529
Communication error.
Cannot read the data.
E535
The data may be corrupted.
Loading the image file has been failed.
E538
This file cannot be used.
E540
Failed to load the captured image.
Failed to register calibration data.
E543
Snap all the dots on the calibration sheet
only without zooming in.
Failed to register calibration data.
E544
Snap only dots of the entire calibration
sheet without zooming in.
Failed to load the captured image.
E548
Use an image that captured the whole mat
without zooming in.
Causes / Solutions
Check the following.
- Check that your wireless access point/router is turned on.
- Check that the network cable of your wireless access
point/router is plugged in.
The wireless connection was incorrectly set up.
Check the settings for the SSID and security information
(SSID/authentication method/encryption method/network
key (password)).
A machine that can be connected cannot be found.
Make sure that the machine has been turned on.
Check the following.
- Check that the settings for the SSID and security
information (SSID/authentication method/encryption
method/network key (password)) have been correctly
specified.
- Check the status of the network connection.
- A network connection has not yet been established. Wait a
while, and then try connecting again.
The proxy settings are incorrect.
Check the proxy settings of your wireless network and your
machine.
A network error occurred during communication.
Check the following.
- Check that your wireless access point/router is turned on.
- Check that the network cable of your wireless access
point/router is plugged in.
This message appears when you try to transfer data with a
machine different than the one registered with
ScanNCutCanvas. Register the machine again.
Registration of your machine has been deleted from
ScanNCutCanvas. Register the machine again.
Select the same connection method as that selected on the
machine.
For details on selecting the same connection method as
that on the machine, see "CONNECTING THE MACHINE
AND COMPUTER" on page 12.
Check the following.
- The machine must be turned on.
- The USB cable must be correctly plugged in.
The selected photo cannot be used.
Select an image photographed under the specified
conditions.
The file may be corrupted.
Select a different image file.
Make sure enough space is available on the device.
The calibration data cannot be registered.
The calibration sheet was photographed too close.
Select an image photographed under the specified
conditions.
The calibration data cannot be registered.
The calibration sheet was photographed too far.
Select an image photographed under the specified
conditions.
The entire mat was not photographed.
Take the photo without zooming and so the entire mat
completely fills the camera screen.
4
61
Advertisement
Table of Contents
