Table of Contents
Advertisement
SETTINGS SCREENS
Settings for various functions can be selected or
changed.
Machine Settings
Press
or
in the operation panel to display
the settings screen. After changing the settings, press
to apply.
■ 1. Network
1. WLAN Enable
Select whether or not to connect to the wireless
network.
2. Setup Wizard
Uses a wizard for manually entering the network key
for the detected SSID to connect to the wireless
network from this machine.
3. WAW
Uses the dedicated application "WLAN Assistant
Wizard" to connect to the wireless network from a
computer.
4. WAW <USB>
Uses the dedicated application "WLAN Assistant
Wizard" to retrieve the wireless LAN settings file from
the computer connected by the USB cable, then
connect to the wireless network.
5. Others
Displays the following parameters for other wireless
network settings.
1. TCP/IP: TCP/IP settings can be manually entered.
2. MAC Address: Displays the MAC address.
3. SSID: Displays the network SSID when a wireless
network connection is established.
4. Network Reset: Resets all network settings to their
defaults. When the following message appears, press
to select [Yes], and then turn the machine off,
then on again.
Reset Network?
▼Yes ▲No
■ 2. Machine Info
1. No.
Displays the machine number for this machine.
2. Ver.
Displays the version of this machine's software.
3. Name
Displays the name that was specified for the machine
connected to DesignNCut Manager (application for
selecting cut settings).
■ 3.Basic Setup
1. Language
Select the machine's display language.
2. Panel Contrast
Adjust the brightness of the LCD.
3. Mark Sensor
In CaptureMat function, the cutting position can be
manually adjusted if it has shifted.
Memo
• "*" appears to the right of the selected item.
■ 4. Machine No.
Displays the machine number for this machine.
Auto Shut Down
If the machine is not used for a specified length of
time, it will automatically turn off. The length of time
until the machine turns off can be specified in the
Settings dialog box of DesignNCut Manager
(application for selecting cut settings).
For details on specifying the settings, see
"DesignNCut Manager Settings" on page 10.
1
9
Advertisement
Table of Contents
