Using Drawing Functions To Fill Patterns/Make Outlines Thicker - Brother 891-Z08 Operation Manual

Using Drawing Functions to Fill
Patterns/Make Outlines Thicker
Note
• Depending on the material and pen being used,
material drawn with a filled pattern may be
difficult to peel off or may tear. Perform trial
drawing with the pattern to be used in your
project.
• To fill in the pattern, select the [Fill the area in
the outline with the drawing function] check box
in the [Properties] dialog box in
ScanNCutCanvas, and then send the pattern to
the machine.
Memo
• An open pattern cannot be filled.
Example:
• The fill settings will be applied to all patterns in
the pattern preview window.
• Fill and outline settings cannot both be
specified for the same pattern.
■ Filling Patterns
a
c
See steps through
page 39 to specify the drawing settings.
b
Click [Apply].
Various fill settings can be specified.
c
Click the [More...] to display the fill settings
screen.
The settings can also be changed by clicking [Settings]
in the [DesignNCut] menu of the main window.
c
b e
e
in "Drawing" on
Memo
• With the mobile device version: Preview
Window →[Settings] → [FILL / ADDITIONAL
LINE] or Main window→
[Operation]
d
After selecting a design under [Fill Pattern],
specify settings for [Fill Line Spacing] and [Fill
Direction], and then click [OK].
a
b
c
a Fill Pattern
Select the fill pattern.
b Fill Line Spacing
Adjust the spacing of the lines filling the pattern.
c Fill Direction
Adjust the direction of the fill pattern.
e
Click [Start] to begin drawing.
→[Settings] →
3
41