Adjusting The Mark Sensors - Brother 891-Z08 Operation Manual

Adjusting the Mark Sensors

If the cutting position is misaligned when cutting
using the "CaptureMat" function, the machine can
be manually adjusted.
If the cutting position is shifted upward or
●
downward from the actual pattern:
b
Refer to step .
If the cutting position is shifted right or left from
●
the actual pattern:
c
Refer to step .
Note
• Check the shift of the cutting position with the
mat in the same orientation as when it was fed
out.
a
From the machine's settings screen, select
[3.Basic Setup], then [3.Mark Sensor].
b
Press or to select the vertical
adjustment value, and then press
The following message appears.
Vertical 0
Example: If the vertical adjustment value was changed
from 0 to 2
(Before change After change
• If the cutting position is shifted upward, increase
the value. If the cutting position is shifted
downward, decrease the value.
c
Press
adjustment value, and then press
Example: If the horizontal adjustment value was
changed from 0 to -5
(Before change
• If the cutting position is shifted to the left, increase
.
)
or to select the horizontal
The following message appears.
Horizontal 0
After change
the value. If the cutting position is shifted to the
right, decrease the value.
.
)
4
53