Brother 891-Z08 Operation Manual page 59

When Setting Up the Wireless Network
Error Messages (Cutting Machine)
Connection failed (Err-01). Press [OK] button.
Connection failed (Err-02). Press [OK] button.
Connection failed (Err-03). Press [OK] button.
Network key error (Err-04). Press [OK]
button.
Connection failed (Err-05). Press [OK] button.
Connection failed (Err-20). Press [OK] button.
Connection failed (Err-06). Press [OK] button.
Connection failed (Err-07). Press [OK] button.
Connection failed. Press [OK] button.
58
The wireless network setting is not activated.
Activate the wireless network.
The wireless access point/router cannot be detected.
1. Check the following 4 points.
- Make sure that the wireless access point/ router is powered on.
- Move your machine to an area with no items which obstruct the wireless
network signal, such as metal doors or walls, or closer to the wireless
access point/router.
- Temporarily place your machine within about 1 m (3.3 feet) from the
wireless access point when you are configuring the wireless settings.
- If your wireless access point/router is using MAC address filtering,
confirm the MAC address of this machine is allowed in the filter.
2. If you manually entered the SSID and security information (SSID/
authentication method/encryption method/Network Key (Password)),
the information may be incorrect. Reconfirm the SSID and security
information and re-enter the correct information as necessary.
The Authentication/Encryption methods used by the selected wireless
access point/router are not supported by your machine.
For infrastructure mode, change the authentication and encryption
methods of the wireless access point/router.
Your machine supports the following authentication methods:
Authentication method
WPA-Personal
WPA2-Personal
Open
Shared key
If your problem is not solved, the SSID or network settings you entered
may be incorrect. Reconfirm the wireless network settings.
The security information (SSID/Network Key (Password)) is incorrect.
Reconfirm the SSID and security information (Network Key (Password)).
The wireless security information (Authentication method/Encryption
method/Network Key (Password)) is incorrect.
Reconfirm the wireless security information (Authentication method/
Encryption method/Network Key (Password)) in the table of Err-03.
This machine is still trying to establish a connection with the wireless
network.
Wait a while, and then check the wireless LAN connection status.
This machine cannot detect a wireless LAN access point/router with WPS
enabled.
Operations must be performed on both this machine and the wireless
LAN access point/router in order to use WPS to set up the wireless
connection.
For details on using WPS with your wireless LAN access point/router,
refer to its manual, or contact its manufacturer or your network
administrator.
Two or more wireless LAN access points/routers with WPS enabled have
been detected.
Make sure that there is only one wireless LAN access point/router with
WPS enabled within the signal range, and then try performing setup
again.
Turn off your wireless LAN router, and then turn it on again.
Then, try again to set up the wireless connection.
Cause/Solution
Encryption method
TKIP
AES
AES
WEP
None (without encryption)
WEP