Internal Peripheral Device Connections; At Power Connection; Figure 4-19: Power Cable To Motherboard Connection - IEI Technology NANO-ULT3 User Manual

4.8 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the on-board connectors

4.8.1 AT Power Connection

Follow the instructions below to connect the NANO-ULT3 to an AT power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-ULT3.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 2.
Step 2: Connect the power cable to the motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the power connector on the motherboard. See
Figure 4-19.

Figure 4-19: Power Cable to Motherboard Connection

Page 64
NANO-ULT3 SBC