Creating An Mcc Chart - Siemens SIMOTION SCOUT Configuration Manual

Result
The MCC source is created.
● The source appears in the project navigator below the PROGRAMS branch.
● The declaration table of the source opens in the working area of the workbench. The
variables declared there apply within the MCC source and can be linked in other sources.
Figure 6-28 MCC source "motion" inserted
6.6.2.3

Creating an MCC chart

Procedure
To insert an MCC chart, proceed as follows:
1. Open the PROGRAMS folder below the SIMOTION device in the project navigator.
2. In the PROGRAMS folder, open the MCC source, motion in the example.
SIMOTION SCOUT
Configuration Manual, 11/2016
Configuring/parameterizing
6.6 Programming the SIMOTION application
115